TABLE OF CONTENTS
2
2
3
5
6
8
10
I.
General Information
II.
Standard Ceiling Plenum Control Panel
III.
Standard Ceiling Plenum Operation
IV.
Maintenance
V.
Wall Thermostat Identification And Operation
VI.
Optional Solar Battery Chargers
VII.
Warranty Service
SECTION I - GENERAL INFORMATION
NOTE
The optional Elect-A-Heat heating assembly is intended to
take the chill out of the indoor air when the air is a few
degrees too cool for comfort. The heating assembly is an
effective "chill chaser". It is not a substitute for a furnace.
These air conditioners were designed to operate from a
115 VAC, 60 HZ, 1 Phase power supply. Anytime an air
conditioner is not operating properly, the power supply should
be examined by a qualified technician to verify that the air
conditioner is receiving the proper power supply.
When searching for a qualified technician, please reference
your RV Products Authorized Service Center List. The
servicers listed are familiar with your Recreation Vehicle
product. If the air conditioner is still under warranty, an
authorized servicer must be used for any repair required on the
air conditioner. Using an unauthorized servicer may void
your warranty.
This is due to the limited electrical power normally available
in most trailer parts and/or economic limitations on the use of
generators with enough capacity to handle large air
conditioners. If more than 1 ton of cooling is desired, then the
use of two air conditioners is recommended.
The ability of the air conditioner to maintain the desired inside
temperature depends on the heat gain of the recreational
vehicle.
The size of the vehicle, amount of window area, amount of
insulation, direct exposure to the sun, outside temperature and
the number of people in the recreational vehicle may increase
the heat gain to such an extent that the capacity of the air
conditioner is exceeded.
As a general rule, air entering the air conditioner will be
cooled about 15 to 20 degrees, depending on the outside
temperature and humidity conditions.
For example, if the air entering the return air grilles in the air
conditioner is 80°F, the air leaving the discharge grilles in the
air conditioner will be 60° to 65°F.
As long as this temperature difference is being maintained
between the return air and discharge air, the air conditioner is
operating at its capacity. If the desired inside temperature
(normally 80°F) cannot be maintained, then the heat gain of
the RV is too great for the capacity of the air conditioner.
Parking the vehicle in a shaded area, keeping windows and
doors shut and avoiding the use of heat producing appliances
in the vehicle will help to reduce the heat gain. When
possible, the addition of insulation and tinted glass (especially
in uninsulated vans) should be considered.
SECTION II - CONTROL PANEL
If your RV air conditioner is operated from the control panel
located in the ceiling assembly, then there are three controls
on the ceiling assembly that help you control the air
conditioner. They are as follows:
A.
The Selector Switch - The selector switch determines
which mode of operation the air conditioner will be
in. By rotating the selector switch, the operator can
obtain any system function desired. System
functions vary depending upon options of both the
roof top unit and ceiling assembly. Figures 1 and 2
show selector switch location and list all available
functions by model.
The "Operation" section explains the operational
characteristics of each mode of operation.
2
(28 stránky)
(16 stránky)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentáře k této Příručce