RV Products 8000 Series Provozní pokyny stáhnout pdf (Strana 3)

SELECTOR SWITCH



TEWPERATURE SWITCH

LOUVERS



The Thermostat (temperature control) - In the



Louvers - The louvers are located at both ends of the

cooling mode, the thermostat regulates the "ON"



ceiling assembly shroud and are used in directing the

and "OFF" temperature setting at which the



discharge air from the unit.

compressor will operate.

For "Heat/Cool" models, the thermostat also controls

the "ON" and "OFF" temperature settings of the

heater assembly. See Figures 1 and 2.

FIGURE 1

[

ram -:

SELECT

•

NI IAN

COM

•

COOL

orr•

WARNER • •

■

911ci\

0 •

•

COMER w



TEMP

COOLING ONLY MODELS

f/i11011:14W



• NI IAN

•

GONER

• •

•

• TEMP

•

rAN

•

HEAT

SELECT



arr.

COOL

•

COOLING / HEATING MODELS

7330 SERIES CEILING ASSEMBLY DECALS

FIGURE 2

SECTION III - OPERATION



For Cooling (Refer to Figure 1 and 2, page 3).



rises a few degrees above the setting you have

selected. When the temperature of the air entering

Turn the selector switch to the "LOW COOL" or



continue to cycle the compressor on and off in the

"HIGH COOL" position.



above mentioned fashion until the selector switch is

turned to another mode of operation.

Rotate the thermostat (temperature control) to the

position that is the most comfortable to you. The



Position the louvers to the desired direction the

thermostat will turn the compressor on when the



discharge air is to flow.

temperature of the air entering the air conditioner

1 2 3 4 5 6 7 8 ... 11 12

Komentáře k této Příručce

Žádné komentáře

RV Products 8000 Series Provozní pokyny Strana 3

Komentáře k této Příručce

Související produkty a manuály pro Split-systém klimatizace RV Products 8000 Series